Ricoh MPC 2800 AT-C2 Mode D'emploi page 537

Pattern Selection
0 None
1: Vertial Line (1dot)
2: Vertial Line (2dot)
3: Horizontal Line (1dot)
4: Horizontal Line (2dot)
003
5: Grid Vertical Line
6: Grid Horizontal Line
7: Grid Pattern Small
8: Grid Pattern Large
9: Argyle Pattern Small
10: Argyle Pattern Large
005 Color Selection
006 Density: Bk
007 Density: M
008 Density: C
009 Density: Y
2111 [Forced Line Position Adj.]
001 Mode a
002 Mode b
003 Mode c
- [0 to 23 / 0 / 1/step]
11. Independent Pattern (1-dot)
12. Independent Pattern (2-dot)
13. Independent Pattern (4-dot)
14. Triming Area
16: Tooth Check (Horizontal)
17: Band (Horizontal)
18: Band (Vertical)
19: Checker Flag Pattern
20: Grayscale (Vertical Margin)
21: Grayscale (Horizontal Margin)
23: Full Dot Pattern
Specifies the color for the test pattern.
- [1 to 4 / 1 / 1/step]
1: All colors, 2: Magenta, 3: Yellow, 4: Cyan
-
Specifies the color density for the test pattern.
-
[0 to 15 / 15 / 1 /step]
0: Lightest density
-
15: Darkest density
-
Executes the fine line position adjustment twice.
-
If this SP is not completed (NG is displayed), do
SP2111-003 first and then try this SP again.
Executes the fine line position adjustment once.
-
If this SP is not completed, do SP2111-003 first and
then try this SP again.
Executes the rough line position adjustment once.
After doing this SP, make sure to execute
-
SP2111-001 or -002. Otherwise, the line position
adjustment is not perfectly done.
System Service Mode
8
169