Ricoh MPC 2800 AT-C2 Mode D'emploi page 606

8. Appendix: SP Mode Tables
Selects the LD power control mode.
Pre-ACC
004
Selects the process control mode that is done before ACC.
3043 [TD Adjustment Mode]
Repeat Number: Power ON
Specifies the maximum number of repeats of the toner density adjustment at power on.
0: Disabled, 1 to 3: Repeat number,
001
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Repeat Number: Initialization
8
Specifies the maximum number of repeats of the toner density adjustment at the developer
initialization.
0: Disabled, 1 to 3: Repeat number,
002
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Repeat Number: Non-use
Specifies the maximum number of repeats of the toner density adjustment in stand by mode.
0: Disabled, 1 to 3: Repeat number,
003
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
238
1: CONTROL (adjusted by process control)
[0 to 2 / 2 / 1/step]
0: Not Executed
*ENG
1: Process Control
2: TC Control (TD Adjustment)
*ENG [0 to 9 / 4 / 1 time/step]
*ENG [0 to 9 / 3 / 1 time/step]
*ENG [0 to 9 / 0 / 1 time/step]