Ricoh MPC 2800 AT-C2 Mode D'emploi page 670

8. Appendix: SP Mode Tables
Productivity priority:
This changes the feeding tray as soon as the machine detects the priority tray even the paper
still remains in the feeding tray.
Tray priority:
This changes the feeding tray after the paper in the tray where the machine has been feeding
paper has been run out of.
This SP is activated only when a customer selects the "Auto Paper Selsct".
5196 [90 degree rotation (copy)] Not used
001 -
5199 [Paper Exit After Staple End.]
001 -
Enables or disables the paper feeding out from the finisher without stapling.
• If this setting is "1: ON", paper is fed out without stapling at the maximum number of
8
• If this setting is "0: OFF", paper is fed out with stapling at the maximum number of the
5212 [Page Numbering]
This program adjusts the position of the second side page numbers.
A "– value" moves the page number positions to the left edge. A "+ value" moves the page
number positions to the right edge.
003 Duplex Printout Right/Left Position
004 Duplex Printout High/Low Position
[Set Time]
Adjusts the RTC (real time clock) time setting for the local time zone.
5302
Examples: For Japan (+9 GMT), enter 540 (9 hours x 60 min.)
DOM: +540 (Tokyo)
NA: -300 (New York)
302
*CTL
*CTL
the finisher stapling when the machine gets a multiple printing job (over maximum
number).
finisher stapling when the machine gets a multiple printing job (over maximum number).
-
[ 0 or 1 / 0 / -]
0: OFF, 1: ON
*CTL
[–10 to 10 / 0 / 1 mm/step]
[–10 to 10 / 0 / 1 mm/step]