Ricoh MPC 2800 AT-C2 Mode D'emploi page 528

8. Appendix: SP Mode Tables
015 Junction Gate SOL1:ON:Plain
016 Junction Gate SOL1:ON:Thick
017 Junction Gate SOL1:OFF:Plain
018 Junction Gate SOL1:OFF:Thick
[Fan Cooling Time Set]
1950
Adjust the rotation time for each fan motor after a job end.
002 Fusing Exit Fan
006 Main Suction Fan
007 Paper Exit Fan
008 PSU Fan
011 Second Duct Fan
012 Third Duct Fan
013 Right-rear Suction Fan
8
SP2-XXX (Drum)
[Charge DC: Correction] Charge Roller DC Voltage Correction
2005 (Paper Type, Process Speed, Color)
Paper Type –> Plain, Thick 1, Thick 2
Adjusts the DC component of the charge roller bias in the various print modes.
Charge bias (DC component) is automatically adjusted during process control; therefore,
adjusting these settings does not effect while process control mode (SP3-041-1 Default: ON)
is activated. When deactivating process control mode with SP3-041-1, the values in these
SP modes are used for printing.
001 Plain: Bk
002 Plain: M
003 Plain: C
004 Plain: Y
160
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG [0 to 60 / 0 / 1 sec/step]
*ENG
*ENG
*ENG
*ENG
*ENG
[0 to 1000 / 690 / 10 –V/step]
*ENG
*ENG