Ricoh MPC 2800 AT-C2 Mode D'emploi page 677

These SP codes determine how the authentication failures are displayed.
001 System Log Disp
002 Panel Disp
5490 [MF Key Card (Japan only)]
001 -
5501 [PM Alarm]
001 PM Alarm Level
002 Original Count Alarm
5504 [Jam Alarm]
Sets the alarm to sound for the specified jam level (document misfeeds are not included).
[0 to 3 / 3 / 1 /step]
001
0: Zero (Off)
1: Low (2.5K jams)
Determines whether an error code appears in the
system log after a user authentication failure occurs.
*CTL
[0 or 1 / 0 / 1]
0: Off, 1: On
Determines whether an error code appears on the
operation panel after a user authentication failure
occurs.
*CTL
[0 or 1 / 1 / 1]
1: On, 0: Off
Sets up operation of the machine with a keycard.
[0 or 1 / 0 / 1]
*CTL
0: Disabled. Cancels operation without a user
code.
1: Enabled. Allows operation without a user code.
*CTL -
[0 to 9999 / 0 / 1 /step]
0: Alarm off
1 to 9999: Alarm goes off when Value (1 to 9999) x 1000
≥ PM counter
[0 or 1 / 1 / – ]
0: No alarm sounds
1: Alarm sounds after the number of originals passing
through the ARDF ≥ 10,000
*CTL -
System Service Mode
8
309