Ricoh MPC 2800 AT-C2 Mode D'emploi page 640

8. Appendix: SP Mode Tables
004 Pixel Count After Near Full
005 Pixel Count After Replacement
008 Coefficient
Notice Setting
011
NOTE:
If the toner collection bottle has been replaced before the machine detects used toner near
full when this setting is set to "0", the machine cannot detect toner collection bottle near full.
In that case, set SP3-902-017 to "1".
Day Threshold: Toner
Collection bottle:NF
012
Sets the threshold days for the near-full display. The near-full of the toner collection bottle is
displayed after the toner collection full sensor has detected the actuator in the toner collection
bottle.
8
013 Total:Toner Collection Bottle
014 Mechanism Full Detection Date
[Toner Collection Bottle Full Detection]
3900
Turns toner collection bottle full detection on or off.
001 ON/OFF Setting
[New PCU Detection]
3901
Turns new PCU detection on or off.
001 ON/OFF Setting
272
*CTL [0 to 200000 / - / 1 cm
Displays the pixel counter after replacement of
toner collection bottle.
*CTL
[0 to 200000 / - / 1 cm
*ENG [0.5 to 1.5 / 1 / 0.1 /step]
Enables or disables the calling for @Remote.
[0 or 1 / 1 / - ]
*ENG
0: Enable @Remote calling
1: Disable @Remote calling
*ENG [1 to 30 / 5 / 1 day/step]
Displays the total amount of the used toner.
*ENG
[0 to 999999999 / 1 / 1]
Displays the date of the full detection fot the
*ENG
toner collection bottle.
[0 or 1 / 1 / - ]
*ENG
0: OFF, 1: ON
*ENG [0 or 1 / 1 / - ]
2
/step]
2
/step]