Ricoh MPC 2800 AT-C2 Mode D'emploi page 643

[Scan]
4014
Execute the scanner free fun with each mode.
001 HP Detection Enable
002 HP Detection Disable
4020 [Dust Check]
001 Detection: ON/OFF
002 Dust Detect: Level
003 Correction Level
[APS Operation Check]
4301
Displays a code that represents the original size detected by the original sensors. (See "Input
Check Table".)
001 APS Operation Check
[APS Min Size (A5/HLT/16K)]
4303
Specifies the result of the detection when the outputs from the original sensors are all OFF.
APS Min. Size (A5/HLT/
001
16K)
- Scanner free run with HP sensor check.
- Scanner free run without HP sensor check.
Turns the ADF scan glass dust check on/ off.
*ENG [0 or 1 / 0 / 1 /step]
0: OFF, 1: ON
Selects the detect level.
[0 to 8 / 4 / 1 /step]
*ENG
0: lowest detection level
8: highest detection level
Selects the level of the sub scan line correction
when using the ARDF.
[0 to 4 / 0 / 1 /step]
0: Off
*ENG
1: Weakest
2: Weak
3: Strong
4: Strongest
- -
[0 to 2 / 0 / 1 /step]
*ENG
0: No Original
System Service Mode
8
275