Publicité
Specification of high-performance vector convertor
The drive to complete a single cycle stops automatically give a run command to start again.
1: One end of the run to keep the value of the final drive to complete a single cycle, automatically keep running frequency
and direction of the last segment.
2: After the cycle has been completed a drive cycle, the next cycle starts automatically, until the stop command to stop.
Simple PLC power down memory
PC-17
Setting range
PLC down memory refers to memory before running down phase and frequency PLC running, the next phase will continue
to run memory at power-up. Choose not to remember, then every power restart PLC process.
PLC shutdown memory is recorded once before shutdown phase and running frequency PLC running, the next phase will
continue to run the memory at runtime. Choose not to remember, every time you restart the PLC process starts.
Simple PLC running time of segment 0
PC-18
Simple PLC deceleration time of segment 0
PC-19
Simple PLC running time of segment 1
PC-20
Simple PLC deceleration time of segment 1
PC-21
Simple PLC running time of segment 2
PC-22
Simple PLC deceleration time of segment 2
PC-23
Simple PLC running time of segment 3
PC-24
Simple PLC deceleration time of segment 3
PC-25
Simple PLC running time of segment 4
PC-26
Simple PLC deceleration time of segment 4
PC-27
selection
Single digit
0
1
Ten bit
0
1
Setting range
Setting range
Setting range
Setting range
Setting range
Setting range
Setting range
Setting range
Setting range
Setting range
Factory default
Power-down memory selection
Memory is not down
Power off memory
Stop memory selection
Memory does not stop
Stop memory
Factory default
0.0s（h）～6553.5s（h）
Factory default
0～3
Factory default
0.0s（h）～6553.5s（h）
Factory default
0～3
Factory default
0.0s（h）～6553.5s（h）
Factory default
0～3
Factory default
0.0s（h）～6553.5s（h）
Factory default
0～3
Factory default
0.0s（h）～6553.5s（h）
Factory default
0～3
- 133 -
Parameter description
00
0.0s（h）
0
0.0s（h）
0
0.0s（h）
0
0.0s（h）
0
0.0s（h）
0
Publicité
