Télécharger Imprimer la page

MSW Motor Technics MSW-FI-7500 Manuel D'utilisation page 264

Publicité

Specification of high-performance vector convertor
P9-13
Choose whether to output phase loss protection.
P9-14
P9-15
P9-16
Recording drive last three fault types, 0 is no fault. On possible causes and solutions for each fault code, please refer to
Chapter 8 for instructions.
The second fault frequency
P9-17
P9-18
The second fault current
P9-19
The second bus voltage failure
P9-20
Input terminal status at fault second
The second fault output terminal
P9-21
P9-22
The second fault drive status
P9-23
The second fault power-on time
P9-24
The second fault running time
P9-27
The second fault frequency
P9-28
The second fault current
The second bus voltage failure
P9-29
Input terminal status at fault second
P9-30
The second fault output terminal
P9-31
The second fault drive status
P9-32
The second fault power-on time
P9-33
P9-34
The second fault running time
Output phase loss protection selection
Setting range
The first type of failure
The second type of failure
The second (last) fault type
Factory default
Last frequency fault
Last fault current
Last bus voltage fault
Last fault state when the digital input terminals, the order is:
When the input terminals of the corresponding two of N is set to 1,
OFF or 0, the status of all DI converted to decimal display.
Last fault state when the digital input terminals, the order is:
When the input terminals of the corresponding two of N is set to 1,
OFF or 0, the status of all DI converted to decimal display.
Retention
The second power-up time of the last fault
The running time of the last fault
The same with
P9-17~P9-24
- 119 -
Parameter description
1
0: ban
1: allow
0~99

Publicité

loading