Parameter description
Set point
Function
0
No function
1
Forward running (FWD)
2
Reverse running (REV)
Three-wire run control;
3
4
Forward jog (FJOG)
5
Turning points (RJOG)
6
Terminals UP
7
Terminal DOWN
Free stoppage
8
Reset (RESET)
9
Pause operation
10
External fault normally open
11
input
12
Multi-speed terminal 1
13
Multi-speed terminal 2
14
Multi-speed terminal 3
15
Multi-speed terminal 4
Deceleration
time selection
16
terminal 1
Deceleration
time selection
17
terminal 2
Frequency source switching
18
UP / DOWN Setting clear
(terminal, keyboard)
19
Running command
20
switching terminal
21
Ramp stop
PID Time out
22
PLC State reset
23
24
Swing frequency pause
25
Counter input
26
Counter reset
27
Length count input
Specification of high-performance vector convertor
Explanation
The terminal will not be used to "No function" to prevent malfunction.
By external terminal to control forward and reverse drive.
This terminal is used to determine the inverter operating mode is a three-line control mode.
For details, see function code P4-11 ("terminal command mode") instructions.
JOG jog forward running, JOG jog reverse running. Jog frequency jog acceleration and
deceleration time refer to the function code P8-00, P8-01, P8-02 description.
By external terminals a given frequency modification frequency increment, decrement
instruction. Frequency source is set to digital setting, can be adjusted up and down to set the
frequency.
Inverter blocks the output, then stop the process from motor inverter control. This way is same
with freewheel meaning of the P6-10.
Use terminal fault reset function. And RESET function key on the keyboard. This function
is used to implement remote fault reset.
The inverter is stopped, but all operating parameters are memories. Parameters such as PLC,
Wobble parameters, PID parameters. After this terminal signal disappears, the drive back to the
state before stopping the run.
When this signal is sent to the inverter, the inverter reports fault ERR15, troubleshooting
and fault protection according to the operation mode (for details to participate in the
function code P9-47).
By 16 states of the four terminals for speed or 16 other instruction set. 16. for details, see
Table 1.
This four states two terminals, four options to achieve acceleration and deceleration time,
for details, see Table 2.
As to switch to select a different frequency source.
According to the frequency source selection function code (P0-07) is set when a set between the
two frequencies as the source switching frequency source, this terminal is used to switch
between two frequency source.
When the frequency of a given digital frequency reference, this terminal can clear frequency
terminal UP / DOWN keyboard or UP / DOWN changed, so that a given frequency back to
the set value of P0-08.
When the command source is set to terminal control (P0-02 = 1), this terminal can be switched
terminal control and keyboard control.
When the command source is set to the communication control (P0-02 = 2), this terminal can
be switched communication control and keyboard control.
Ensure that the drive is not external signals (except stop command), to maintain the current
output frequency.
PID is temporarily disabled, the inverter maintains the current frequency output, no longer
frequency source PID adjust.
PLC pause in the implementation process, is running again, you can restore the inverter
through this terminal to the initial state of simple PLC.
Drive to the center frequency output. Wobble function pause.
Count input terminal of the pulse.
Counter clearing processing status.
Length count input terminal.
- 86 -