Publicité
Parameter description
The above function codes are generally used to bias the output amplitude and zero drift correction analog output. It can
also be used to customize the desired output curve AO.
If zero offset by "b" represents the gain by k, the actual output by Y, X represents standard output, the actual output is:
Y=kX＋b. Wherein, AO1, AO2 zero-bias factor of 100% corresponds to 10V (or 20mA), it refers to the standard output in
the absence of bias and gain correction, output 0V ~ 10V (or 0mA ~ 20mA) corresponding to the amount of the analog
output.
For example: If the analog output is the operating frequency, at a frequency of 0 output 8V, frequency is the maximum
frequency output 3V, the gain should be set to "-0.50" bias should be set to "80%."
P5-17
P5-18
P5-19
P5-20
P5-21
Set the output terminals FMR, relay 1, relay 2, DO1 and DO2, from state to produce the actual output delay time change
occurs.
P5-22
Define the output terminal of FMR, relay 1, relay 2, DO1 and DO2 output logic.
0: Positive logic, digital output terminal and the corresponding common terminal communicates to the active state,
disconnect inactive state;
1: Anti-logic, digital output terminal and the corresponding common terminal communicates to the inactive state, disconnect
the active state.
FMR output delay time
Setting range
RELAY1
output delay time
Setting range
RELAY2
output delay time
Setting range
DO1
output delay time
Setting range
DO2
output delay time
Setting range
DO terminal output valid state
Single digit
0
1
Setting
Ten bit
range
Hundred bit
Thousand bit
Ten thousand bit DO2 Terminal active set (0-1, supra)
Specification of high-performance vector convertor
Factory default
0.0s～3600.0s
Factory default
0.0s～3600.0s
Factory default
0.0s～3600.0s
Factory default
0.0s～3600.0s
Factory default
0.0s～3600.0s
Factory default
FMR active choice
Positive logic
Inv
RELAY1 Active set (0-1, supra)
RELAY2 Terminal active set (0-1, supra)
DO1 Terminal active set (0-1, supra)
- 98 -
0.0s
0.0s
0.0s
0.0s
0.0s
0
Publicité
