Publicité
Specification of high-performance vector convertor
P8-05
P8-06
P8-07
P8-08
This VFD provides 4 group of acceleration and deceleration time, respectively P0-17 / P0-18 and said 3 group of
acceleration and deceleration time.
4 group define exactly deceleration time, refer to the P0-17 and P0-18 instructions. Through different combinations of
multifunction digital input terminal DI, you can switch between 4 group of acceleration and deceleration time, please refer
to the specific use function code P4-01 ~ P4-05 of instructions.
P8-09
P8-10
P8-11
When the jump frequency range within the set frequency, the actual running frequency will run at a frequency from the set
frequency jump closer. By setting the frequency hopping allows the drive to avoid the mechanical resonance point of load.
VFD can set two skip frequencies, when the two skip frequencies are set to 0, the jump frequency function is canceled.
Principle jump frequency and the amplitude of frequency hopping schematic, refer to Figure 6-14.
Acceleration time 3
Setting range
Deceleration time 3
Setting range
Acceleration time 4
Setting range
Deceleration time 4
Setting range
Skip frequency 1
Setting range
Skip frequency 2
Setting range
Jump frequency range
Setting range
Figure 6-14 Skip frequency schematic
Factory default
0. 0s～6500.0s
Factory default
0. 0s～6500.0s
Factory default
0. 0s～6500.0s
Factory default
0. 0s～6500.0s
Factory default
0.00Hz ~ maximum frequency
Factory default
0.00Hz ~ maximum frequency
Factory default
0.00Hz ~ maximum frequency
- 107 -
Parameter description
20.0s
20.0s
20.0s
20.0s
0.00Hz
0.00Hz
0.00Hz
Publicité
