Installing The Optional Right Fit Oxygen Bottle Holder - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Installing the optional right fit oxygen bottle holder

EN
WARNING
Always adjust the scale or bed exit system if an option is added while the scale or bed exit system is armed.
The optional right fit oxygen bottle holder supports an oxygen bottle in a horizontal position on top of the headboard.
To install the optional right fit oxygen bottle holder:
1. Place the oxygen bottle holder on top of the headboard (A)
2. Screw on the oxygen bottle holder clasp onto the headboard (B)
holder to the product.
3. Route the bottom straps (C) through the headboard handles
4. Attach the bottom straps to their respective fasteners.
5. Insert the oxygen bottle into the bottle holder.
6. Place the oxygen bottle holder cover on top of the oxygen bottle (D)
Note: You can orient the oxygen bottle holder cover opening to face the right or left side of the product.
7. Fasten the oxygen bottle holder cover straps together (E)
1-112
Accessories
D
E
E
Figure 1-133: Right fit oxygen bottle holder
2141-800-1 07 REV A
(Figure 1-133 on page 1-112).
(Figure 1-133 on page
(Figure 1-133 on page 1-112).
(Figure 1-133 on page
(Figure 1-133 on page 1-112).
A
C
B
1-112) to secure the bottle
1-112).
www.stryker.com