Installing The Optional Bed Extender - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Installing the optional bed extender

EN
WARNING
• Always securely set the footboard connector on the optional bed extender into the footboard connector slot at the
foot end of the product.
• Do not pinch the power cord or cables when installing the optional bed extender.
• Do not sit on the optional bed extender. This may cause the product to tip.
The optional bed extender lengthens the product by six inches.
To install the optional bed extender:
1. Strap the appropriate mattress extender cushion onto the optional bed extender
2. Remove the footboard (see
3. Insert the optional bed extender legs (A) and the footboard connector (B) onto the foot end of the product
118 on page
Figure 1-117: Strapping the mattress to the optional
1-102
Removing or replacing the footboard on page
1-102).
bed extender
Accessories
A
Figure 1-118: Attaching the optional bed extender
2141-800-1 07 REV A
(Figure 1-117 on page 1-102).
1-30).
B
A
www.stryker.com
(Figure 1-