Configuring The Visibility Of Patient Information - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Configuring the visibility of patient information

EN
The Configure screen allows you to choose what patient information is displayed on the Patient Information screen.
To configure the visibility of patient information, tap
Configure privacy
To enable visibility of patient information on the Patient
Information screen:
1. Tap the option in the Configure screen that you want
to display (Figure 1-21 on page
Note: Options change from blue (deactivated) to
green (activated) when tapped.
2. Tap Ok.
Note: If the option is not tapped to enable visibility of
patient information, dashes are displayed for the missing
value in the Patient Information screen.
Display Height: Displays the patient's height.
• To increase patient height by 1 (in. or cm), tap the up
arrow (Figure 1-21 on page
• To decrease patient height by 1 (in. or cm), tap the
down arrow
Display Weight From Scale System: Displays the
patient's weight as measured by the scale system.
Calculate BMI: Displays the patient's body mass index
(BMI). You must tap both the Display Height and Display
Weight From Scale System options to calculate the BMI.
Display Last Braden Scale Score: Displays the patient's
last Braden Scale score and the time and date the score
was recorded. If no score has been measured, dashes
are displayed for the missing value.
Display Patient ID: Displays the Patient ID. You can enter
the Patient ID on the New Patient screen
page 1-41).
1-42
(Figure 1-19 on page 1-40).
1-42).
1-42).
(Figure 1-21 on page 1-42).
(Figure 1-20 on
Operation
Display
Height
Braden Scale
Figure 1-21: Configuring private patient information
2141-800-1 07 REV A
Display Weight
6 feet 1" From Scale
System
Calculate BMI
Display Last
Display
Patient ID
Score
O k
www.stryker.com
Ca n c e l