Transporting Intouch By Using The Zoom Motorized Drive (Model 2141) (Option) - Stryker InTouch Critical Care Bed Manuel D'exploitation

Transporting InTouch by using the Zoom motorized drive (Model 2141) (option)

WARNING
• Do not use the Zoom motorized drive when the batteries become discharged. Press N/Brake Off to place the drive
wheel in neutral and push the product manually. Recharge the batteries before using the Zoom motorized drive
again to avoid the risk of battery damage and the drive wheel getting stuck in the down position.
• Use caution while maneuvering the product with the drive wheel activated. Always make sure that there are no
obstacles near the product while the Zoom motorized drive is activated. Injury to the patient, user or bystanders or
damage to the frame or surrounding equipment could occur if you collide with an obstacle.
• Make sure that the brakes are completely released before attempting to move the product. Attempting to move the
product with the brakes applied could result in injury to the patient or operator.
• Always lock the siderails in the full up position with the sleep surface horizontal in the lowest position when
transporting a patient.
• Do not attempt to move the product manually when you activate the Zoom motorized drive. Always place the drive
wheel into the neutral position and release the brakes before attempting to move the product manually.
• Do not attempt to move the product laterally after you apply the Zoom motorized drive. The the Zoom motorized
drive cannot swivel.
Note: To move the product in any direction, including laterally, press N/Brake Off on the brake control panel (see
control panel (outside siderail) on page
head end control panel (optional) (see
InTouch may be equipped with a Zoom motorized drive. The Zoom motorized drive provides mobility and efficient
transport of the product.
To transport InTouch using the drive wheel:
1. Unplug the power cord from the wall outlet.
Note: The Zoom motorized drive does not operate if the power cord is plugged into a wall outlet.
2. Store the power cord on the Zoom handle brackets.
3. Unfold the drive handles from the head end of the product
handles lock into the upright position.
4. Press N/Brake Off to release the brakes.
5. Press D/Drive on the brake control panel, footboard control panel, or head end control panel (optional).
Note: The D/Drive button illuminates when the drive wheel is activated.
6. Make sure that the product is ready for driving.
www.stryker.com
Operation
1-34), footboard control panel (see
Head end control panel (optional) on page
Figure 1-7: Unfolding the Zoom motorized drive handles
2141-800-1 07 REV A
Footboard control panel on page
1-36).
(Figure 1-7 on page 1-23). Make sure that the drive
English
EN
Brake
1-37), or
1-23