Setting The Scale To Zero - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Setting the scale to zero

EN
The zero function clears all of the stored values for weight history, change patient weight, and gain or loss.
To set the scale to zero:
1. Tap Zero (Main menu: Scale on page
2. To confirm setting the scale to zero, tap Ok
24 on page
To cancel the request, tap Cancel
1-46).
Note: The request is cancelled if the bed goes into auto
shutoff.
After confirming setting the scale to zero, a notification
appears (Figure 1-25 on page
Note: To cancel the request, tap Close.
A confirmation notification indicates that setting the scale
to zero was successful
1-46
1-44).
1-46).
(Figure 1-24 on page
1-46).
(Figure 1-26 on page
Operation
(Figure 1-
Figure 1-25: Do not touch bed
1-46).
2141-800-1 07 REV A
Message
S c a le Ze r o ?
Ca n c e l
Figure 1-24: Scale Zero?
Message
Do n o t
t o u c h b e d
Message
Ze r o s u c c e s s !
Figure 1-26: Zero success!
Clo s e
www.stryker.com