Installing The Optional Upright Oxygen Bottle Holder - Stryker InTouch Critical Care Bed Manuel D'exploitation

Installing the optional upright oxygen bottle holder

WARNING
Always adjust the scale or bed exit system if an option is added while the scale or bed exit system is armed.
The optional upright oxygen bottle holder supports an oxygen bottle in a vertical position.
To install the optional upright oxygen bottle holder:
1. Insert the support bar into the socket at the head end or foot end of the product on either side (A)
page 1-111).
Note: Foot end functionality stops when you insert equipment into the sockets at the foot end of the product.
2. Insert the security chain pin (B) through the support bar hole
holder to the product.
www.stryker.com
Accessories
(Figure 1-132 on page
A
B
Figure 1-132: Upright oxygen bottle holder
2141-800-1 07 REV A
(Figure 1-132 on
1-111) to secure the bottle
1-111
English
EN