Using The Retractable Head Section Oxygen Bottle Holder - Stryker Power-PRO XT 6500 Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 99

USING ThE RETRACTABlE hEAD SECTION OXyGEN BOTTlE hOlDER

To attach an oxygen bottle to the retractable head section oxygen bottle holder:
1.
Center the oxygen bottle on the cradled surface of item (A) as shown in Figure 51.
2.
Tighten both straps (B) around the oxygen bottle.
3.
Secure the slack on the straps to the Velcro
B
A
Note: Inspect the straps and clips for wear between use and replace the strap if it is no longer holding the oxygen
bottle.
WARNING
If the cot is equipped with the optional retractable head section oxygen bottle holder, use caution while the oxygen bottle
holder is installed to avoid pinching your fingers between the fowler bracket and the oxygen bottle.
CAUTION
To avoid damage to the retractable head section oxygen bottle holder (if equipped), the weight of the equipment
must not exceed 40 pounds (18 kg).
Do not use two head end oxygen bottle holders at the same time.
www.stryker.com
Optional Accessories
®
on the straps.
Figure 51: Retractable head Section Oxygen Bottle holder
6500-109-005 REV A
Return To Table of Contents
1-59
English

Publicité

Table des Matières
loading

Table des Matières