Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
CAUTION (CONTINUED)
EN
•
Always use only Stryker authorized batteries when replacing the batteries. Use of non-Stryker batteries may lead to
unpredictable system performance.
•
Upon a Battery Low alarm (Battery Low LED on Footboard and audible beep), stop using the Zoom motorized drive
and recharge the batteries immediately. Ignoring the Battery Low alarms may cause your batteries to degrade
quicker than normal and may decrease battery life.
•
Always clean Velcro
Appropriate disinfectant for nylon Velcro should be determined by the hospital.
•
Do not move footboards from one product to another. Individual products may have different options. Mixing
footboards could result in unpredictable operation of the product.
•
Do not use the siderails to move the product. Always move the product using the integrated handles in the
headboard and footboard.
•
Do not use pencils, pen caps, pen tips, or other pointed objects to tap the touch screen display. Using excessive
pressure may damage the footboard control panel and the touch screen display.
•
Always use extra supervision when using a mattress or support surface thicker than six in. (15,4 cm).
•
Do not allow sharp objects to come into contact with the support surface that could puncture, tear, or cut the cover.
•
Do not allow sharp edges from the X-ray plate to come in contact with the support surface cover. The
recommendation is you cover the X-ray plate with a pillow case or other device before placement under the patient.
If damaged, remove the support surface cover from service immediately to prevent cross contamination.
•
Make sure that you set the desired product parameters before enabling iBed® Awareness.
•
Do not use accessories that cover the footboard and outside siderail LED light bars.
•
Do not turn off the iBed
compromised parameter condition.
•
Do not hang IV bags that exceed 22 lb (10 kg) onto the IV pole.
•
Always make sure that the IV pole is at a low height to pass safely through door openings.
•
Do not use the IV pole as a push/pull device.
•
Always make sure that the clip is stable when installed.
•
Do not inset tubes that are larger than 0.75 in. into the line management clip.
•
Always sterilize the clip after each use.
•
Always make sure that the clip is stable when installed.
•
Always unplug the product before cleaning or servicing.
•
Always unplug the product, set the brakes, and place blocks under the litter frame for support when working under
the product.
•
Always make sure that you wipe each product with clean water and thoroughly dry each product after cleaning.
Some cleaning products are corrosive in nature and may cause damage to the product if you use them improperly. If
you do not properly rinse and dry the product, a corrosive residue may be left on the surface of the product that
could cause premature corrosion of critical components. Failure to follow these cleaning instructions may void your
warranty.
•
Do not steam clean, pressure wash, ultrasonically clean, or immerse any part of the product in water. Exposure to
water may damage the internal electric parts. These methods of cleaning are not recommended and may void this
product's warranty.
1-16
Summary of safety precautions
®
after each use. Saturate Velcro with disinfectant and allow disinfectant to evaporate.
®
Awareness alarm. You will lose access to the event manager that displays the
2141-800-1 07 REV A
www.stryker.com
Publicité
Chapitres
Table des Matières
