Restarting A Support Surface Function - Stryker InTouch Critical Care Bed Manuel D'exploitation

Restarting a support surface function

A notification appears (Figure 1-40 on page
InTouch has reset and the Turn Assist or Max Inflate
support surface functions were active. You may need to
restart the interrupted function after receiving this
message.
To restart an XPRT support surface function, see the
instructions in the XPRT support surface operations
manual.
To restart a PositionPRO support surface function, see
the instructions in the PositionPRO support surface
operations manual.
To restart an Isolibrium support surface function,
seeStarting and stopping Turn Assist on page 1-68
Starting and stopping Max Inflate on page
Notes
• The firmness settings for XPRT and PositionPRO
are preserved when the product resets.
• The Pressure Redistribution settings for Isolibrium
are preserved when the product resets.
• The settings for Protocol Reminders are lost when
the product resets.
www.stryker.com
Operation
1-55) after
or
1-70.
Figure 1-40: System reset message
2141-800-1 07 REV A
English
EN
1-55