Starting Lateral Rotation - Stryker InTouch Critical Care Bed Manuel D'exploitation

Starting Lateral Rotation

Note: The first Lateral Rotation cycle performs at a reduced angle before performing a full rotation.
To start lateral rotation:
1. Tap Lateral Rotation on the Support Surface screen.
2. Adjust the Lateral Rotation selections as needed
a. Tap the up and down arrows to increase or decrease the rotation level for patient left side or patient right side.
Notes
• You can only change the Lateral Rotation settings when the therapy stops. You cannot change the Lateral
Rotation settings when the therapy is active or paused.
• When you do not set a rotation level for the patient left side or patient right side, the hold times become
disabled and change to zero.
• When you do not set a rotation level for the patient left and patient right side, a notification appears
Notification — left and right rotation level not seton page
Figure 1-51: Notification — left and right rotation level not set
b. Tap the up and down arrows to increase or decrease the hold times for patient left, patient right, or surface flat
position.
3. Raise all of the siderails to allow Lateral Rotation to start.
Note: If you do not raise all of the siderails, a notification will display
the previous screen.
www.stryker.com
Operation
(Figure 1-50 on page
Figure 1-50: Lateral rotation screen
1-63).
2141-800-1 07 REV A
1-63):
(Figure 1-52 on page 1-64). Tap OK to return to
English
EN
(1-51
1-63