Applying Or Releasing The Manual Brake - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Applying or releasing the manual brake

EN
WARNING
• Always keep feet clear from the area above the base cover or below the base cover when lowering the product or
when applying the brakes or releasing the brakes.
• Always apply the brakes when a patient is getting in the product or out of the product to avoid instability.
• Always apply the brakes when the patient is unattended.
• Do not apply the brake to slow or stop the product while it is in motion.
InTouch is equipped with both a manual and an electric braking system.
You can find the manual brake pedal on the patient right side of the product.
To apply the manual brakes:
1. Flip down the brake pedal (A)
2. Fully depress the brake pedal (A) until Brake appears in the brake pedal window (B)
Note: The Brake button and Brake Set LED illuminate when you apply the brakes.
To release the manual brakes, depress the pedal until Neutral or Drive appears in the brake pedal window (B)
6 on page 1-21).
Note: If you set the brakes manually, they can be released electronically.
1-20
Operation
(Figure 1-5 on page 1-21).
2141-800-1 07 REV A
(Figure 1-6 on page 1-21).
(Figure 1-
www.stryker.com