Installing The Optional Patient Control Pendant Clip - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Installing the optional patient control pendant clip

EN
WARNING
• Do not allow the optional line management clip to interfere with a mechanical or electronic mechanism of the
product.
• Do not pinch tubes inside the clip.
• Do not clean the clip with a liquid solution.
CAUTION
• Always sterilize the clip after each use.
• Always make sure that the clip is stable when installed.
The optional patient control pendant clip supports the patient control pendant in a stable location close to the patient.
To install the optional patient control pendant clip:
1. Raise the clip (A)
2. Secure the patient control pendant clip to a siderail.
1-108
Accessories
(Figure 1-124 on page 1-108).
A
Figure 1-124: Patient control pendant clip
2141-800-1 07 REV A www.stryker.com