Activating The Cpr Release Pedal - Stryker InTouch Critical Care Bed Manuel D'exploitation

Operation
English

Activating the CPR release pedal

EN
WARNING
Always make sure that all persons and equipment are away from the area below and around the product before you
activate the CPR release. The CPR release is for emergency use only.
When the product is raised and quick access to the patient is needed, you can position InTouch quickly to 0° by
activating the CPR release.
Two instant CPR release pedals are located at the head end section on both the left and right sides of the litter (A)
(Figure 1-9 on page 1-25).
To activate the CPR release pedal, fully depress the CPR pedal. The product instantly flattens to 0°.
A
Figure 1-9: CPR release pedal
www.stryker.com 2141-800-1 07 REV A 1-25