Changing The Patient Weight - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Changing the patient weight

EN
To change the patient weight:
Tap Change Weight
To confirm changing the patient weight, tap Ok
29 on page 1-48).
To cancel the request, tap Cancel
1-48).
Note: The request is cancelled if the bed goes into auto
shutoff.
While changing patient weight, a notification appears
(Figure 1-30 on page
Note: To cancel the request, tap Close.
After the scale calibration, you can change the patient
weight (Figure 1-31 on page
• To increase patient weight by .1 (lb or kg), tap the up
arrow.
• To decrease patient weight by .1 (lb or kg), tap the
down arrow.
• To increase patient weight by 1.0 (lb or kg), hold the
up arrow.
• To decrease patient weight by 1.0 (lb or kg), hold the
down arrow.
• To save the desired weight, tap Ok.
• To cancel the request, tap Cancel.
1-48
Operation
(Main menu: Scale on page 1-44).
(Figure 1-
(Figure 1-29 on page
1-48).
1-48).
Message
Figure 1-29: Change patient weight?
Message
Figure 1-30: Do not touch bed
Change Patient Weight
Figure 1-31: Change patient weight
2141-800-1 07 REV A
Ch a n g e
P a t ie n t W e ig h t ?
O k Ca n c e l
Do n o t
t o u c h b e d
Clo s e
Weig h t
0 . 0 lb s
O k Ca n c e l
www.stryker.com