Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
English
Operating nurse call (option)
EN
Nurse call allows a patient to alert an operator when they require assistance.
To activate nurse call, press the nurse call button on the inside siderail (N)
(Figure 1-1 on page
1-11) or on the optional
patient control pendant (see
Patient control pendant (optional) on page
1-35). Communication between the patient and
the nurse station is established when the nursing staff responds to the nurse call signal.
Note: If the communication between the product and the nurse station is interrupted following a power failure, the
disconnection of the nurse call communication cable, or the switching off of InTouch, the nurse call system automatically
sends a signal to the nurse station.
Connecting peripheral equipment to the built-in 110 volt auxiliary power outlet
(optional) and the auxiliary mattress connector
WARNING
Only use hospital-grade electric equipment consuming 5A or less with the auxiliary power outlet (optional). The use of
standard electric equipment may bring the current leakage to a level unacceptable for hospital equipment.
You can use the 110 volt InTouch auxiliary power outlet as a built-in power source for peripheral equipment. The outlet is
located beneath the foot end on the patient left side of the product (A)
(Figure 1-1 on page
1-11). There is a one and two
plug option for the InTouch auxiliary outlet (A)
(Figure 1-12 on page
1-28).
There is also an auxiliary mattress connector outlet for connecting a support surface option to InTouch (B)
(Figure 1-12
on page
1-28). A 5A breaker is also integrated into this power outlet.
Note:
To install a support surface option onto InTouch, see the installation instructions in the support surface operations
manual.
A
B
Figure 1-12: Optional InTouch auxiliary outlets
1-28
2141-800-1 07 REV A
www.stryker.com
Publicité
Chapitres
Table des Matières
