Preparing Bed Positions For Support Surface Functions; Initializing Pressure Redistribution - Stryker InTouch Critical Care Bed Manuel D'exploitation

Preparing bed positions for support surface functions

To prepare bed positions:
1. Raise all of the bed siderails.
2. Lower the bed height to the lowest practical position.
3. Lower the head section to the flat position or as low as possible.

Initializing Pressure Redistribution

Pressure Redistribution provides firmness for the patient based on the weight range and firmness settings.
To initialize Pressure Redistribution:
Tap Pressure Redistribution on the Pressure Redistribution screen
www.stryker.com
Operation
(Figure 1-46 on page
Figure 1-46: Pressure redistribution
2141-800-1 07 REV A
1-59).
1-59
English
EN