Intended use: iBed Wireless
The intended use for the iBed Wireless (with iBed Awareness) is to assist clinical staff to monitor bed parameters on
specific Stryker beds. The desired bed parameters are set by operators at the bedside. The iBed Wireless software is
only intended for use with specifically enabled Stryker beds that have been verified and validated with the iBed Wireless
software, and is not intended to provide bed status information for non-Stryker beds. The iBed Wireless software is not
intended to communicate any patient status information, nor to permanently store any type of data. The iBed Wireless
with iBedAwareness System is not intended to provide automated treatment decisions or as a substitute for professional
healthcare judgment. The iBed Wireless with iBed Awareness System is not a replacement or substitute for vital signs
monitoring or alert equipment. All patient medical diagnosis and treatment are to be performed under direct supervision
and oversight of an appropriate healthcare professional.
Expected service life
InTouch has a 10 year expected service life under normal use conditions and with appropriate periodic maintenance.
Contraindications
InTouch is not intended to:
•
be used without a support surface
•
use the scale output to determine diagnosis or treatment
•
be used with an oxygen tent
•
support more than one individual at a time
•
be used with patients that are 35 in. or less
•
be used with patients that weigh 50 lb or less
•
be used on patient less than two years old
•
be used in a home healthcare environment
•
be used in the presence of flammable anesthetics
Specifications
Safe working load
Note: Safe working load indicates the
sum of the patient, mattress, and
accessory weight
Product weight
Product length
Siderails up
Product width
Siderails down
Under product clearance
Base
www.stryker.com
Introduction
®
with iBed Awareness
2141-800-1 07 REV A
500 lb
340,2 kg
750 lb
228,6 cm
90 in.
106,7 cm
42 in.
102,9 cm
40 in.
12,7 cm
5 in.
English
EN
227 kg
1-7