Installing The Optional X-Ray Cassette Holder - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Installing the optional X-ray cassette holder

EN
The optional X-ray cassette holder attaches to the fowler to support X-ray cassettes. You can take X-rays while a patient
is on the product. You can also adjust the cassette's position before taking an X-ray.
Tools required:
• #2 Phillips screwdriver
To install the optional X-ray cassette holder:
1. Apply the brakes.
2. Raise the fowler section to its full height.
3. Turn the battery switch to the OFF (O) position.
4. Unplug the power cord from the wall outlet.
5. Using a #2 Phillips screwdriver, install two screws to secure the fastener (A) to the top of the fowler frame
137 on page
6. Using a #2 Phillips screwdriver, install four screws to secure the two cassette holder pivot brackets (B) into the lower
fowler section
7. Using a #2 Phillips screwdriver, install two screws and two spacers to secure the X-ray cassette holder (C) into the
cassette holder pivot brackets (B)
Note: Always close the X-ray cassette holder when not in use.
1-116
1-116).
(Figure 1-137 on page 1-116).
(Figure 1-137 on page
B
Figure 1-137: X-ray cassette holder
Accessories
1-116).
B
A
2141-800-1 07 REV A
(Figure 1-
www.stryker.com