Installing The Optional Traction Sleeves - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Installing the optional traction sleeves

EN
The optional traction sleeves allow you to install traction equipment. Five different traction sizes are available. You can
use these installation instructions to install all size configurations.
Tools required:
• Four washers
• Four bolts
• 7/16 in. combination wrench
To install the optional traction sleeves:
1. Install the traction sleeves into the sockets at the head end and foot end of the product (A)
114).
Note: Foot end functionality stops when you insert equipment into the sockets at the foot end of the product.
2. Using a 7/16 in. combination wrench, install one washer (B) and one bolt (C) to secure the traction sleeve in the
socket (Figure 1-135 on page
Note: The bolts are coated in Scotch Grip. You must replace the bolt with an identical equivalent if the bolt is
removed during a service procedure.
3. Repeat step 2 to install the remaining traction sleeves.
B
1-114
Accessories
1-114).
A
C
Figure 1-135: Traction sleeves
2141-800-1 07 REV A
(Figure 1-135 on page 1-
A
www.stryker.com