Connecting A Support Surface To Intouch; Main Menu: Surfaces - Stryker InTouch Critical Care Bed Manuel D'exploitation

Connecting a support surface to InTouch

WARNING
• Do not use extension cords with support surfaces. Support surfaces are only intended to be powered by InTouch
with the power cord supplied.
• Do not route cables between the support surface and InTouch.
1. Install the support surface onto InTouch.
Note: To install a support surface option onto
InTouch, see the installation procedures in the
appropriate support surface operations manual.
2. Connect the integration cable from the support
surface to the auxiliary mattress connector (B)
(Figure 1-35 on page 1-53).
3. Plug the support surface power cord into the auxiliary
mattress connector outlet (A)
53).

Main menu: Surfaces

InTouch can detect if a support surface is connected to
the auxiliary mattress connector.
If you tap Surfaces on the navigation bar
page 1-53) and there is no support surface connected to
InTouch, a notification appears
53).
www.stryker.com
Operation
(Figure 1-35 on page 1-
(Figure 1-37 on
(Figure 1-36 on page 1-
2141-800-1 07 REV A
A
Figure 1-35: Auxiliary mattress connector outlet
No mat
P le a s e c h e c k c a b le
c o n n e c t io n s
Figure 1-36: No mattress detected
Figure 1-37: Navigation Bar
English
EN
B
t r e s s d e t e c t e d .
1-53