Installing The Optional Wall Saver - Stryker InTouch Critical Care Bed Manuel D'exploitation

Installing the optional wall saver

The optional wall saver helps mitigate damage to the wall and to the product by disconnecting the 37 pin connector when
you move the product away from the wall without first unplugging the product.
Tools required: None
To install the optional wall saver:
1. Insert the pin end of the first connector (A) into the head end of the product
2. Screw the connector fasteners (B) in to secure the connector to the product
3. Connect the back end of the second connector into the back end of the first connector (C)
115).
4. Insert the pin end of the second connector (D) into the wall
5. Screw the connector fasteners (E) in to secure the connector to the wall
D
www.stryker.com
Accessories
B
A
C
E
E
Figure 1-136: Wall saver connections
2141-800-1 07 REV A
(Figure 1-136 on page
(Figure 1-136 on page
(Figure 1-136 on page 1-115).
(Figure 1-136 on page
B
1-115).
1-115).
(Figure 1-136 on page 1-
1-115).
1-115
English
EN