Stryker InTouch Critical Care Bed Manuel D'exploitation page 30

English
Transporting InTouch by using the Zoom motorized drive (Model 2141) (option)
EN
(Continued)
Two LEDs on the drive handle indicate whether the product is ready for driving
Notes
• If the green LED is on, the battery is charged, and you may use the Zoom motorized drive for driving.
• If the amber LED is on and the battery is at low charge, the Zoom motorized drive should not be used. InTouch
requires two 12 volt batteries to provide power to the Zoom motorized drive. The Zoom motorized drive will not
operate properly if the batteries are not sufficiently charged. Plug InTouch into a wall outlet to charge the
batteries before using the Zoom motorized drive.
7. Grasp the yellow triggers on the Zoom drive handles.
Note: You can squeeze one or both triggers to enable movement, but you must release both triggers to stop
movement.
8. While squeezing the triggers, push the handles away from you or pull the handles toward you to initiate motion in the
desired direction. The speed increases proportionally to the amount of force applied to the drive handles. When you
reach the desired speed, the Zoom motorized drive maintains the speed and direction with no extra push force.
9. To accelerate, push or pull the handles again until you reach the desired speed.
10. Relax the force to a neutral position to maintain speed.
11. To slow down, push or pull the handles in the opposite direction the product is currently moving.
12. To stop motion, you must release both triggers on the drive handles.
WARNING
Do not use the brake to slow or stop the product while it is in motion.
1-24
Operation
Figure 1-8: Zoom motorized drive handle LEDs
2141-800-1 07 REV A
(Figure 1-8 on page 1-24):
QE71-1372-A
www.stryker.com