Starting And Stopping Turn Assist - Stryker InTouch Critical Care Bed Manuel D'exploitation

English

Starting and stopping Turn Assist

EN
WARNING
• Always make sure that the tubing and wiring that is connected to the patient is long enough, stable, and secure
during Lateral Rotation or Turn Assist.
• Always raise all of the InTouch bed siderails before beginning Turn Assist or Lateral Rotation.
• Do not leave the patient unattended during Turn Assist.
• Do not zero the bed scales or weigh the patient with Lateral Rotation or Turn Assist active. Motion from the support
surface functions may adversely affect the scale system performance.
• Do not arm bed exit with Lateral Rotation or Turn Assist active. The patient motion and position that results from the
support surface may adversely affect bed exit system performance.
To start Turn Assist:
1. Raise all of the bed siderails.
2. Center the patient on the support surface.
3. Tap Turn Assist
4. Select Hold Side by tapping turn the patient left or patient right.
5. Select Hold Time by tapping one of the three options:
a. 15 sec
b. 30 min
c. 120 min
Note: Make sure that the head of bed (HOB) angle is less than or equal to 60° to avoid the therapy cannot be started
notification (Figure 1-62 on page
1-68
(Figure 1-61 on page 1-68).
Figure 1-61: Turn assist screen
1-69).
Operation
2141-800-1 07 REV A www.stryker.com