Installing The Optional Monitor Tray - Stryker InTouch Critical Care Bed Manuel D'exploitation

Installing the optional monitor tray

WARNING
Always adjust the scale or bed exit system if an option is added while the scale or bed exit system is armed.
The optional monitor tray supports a monitor at the foot end of the product.
Note: Make sure that the litter is flat before you install the optional monitor tray.
To install the optional monitor tray:
1. Install the bracket back (A) and the bracket (B)
hook at the foot end of the product (C and D)
2. Install the screw knob onto the bracket back (E)
3. Rotate the bracket over the socket at the foot end of the product.
4. Install the tray support pole into the bracket (F) and into the socket at the head end or foot end of the product
(Figure 1-128 on page 1-109).
Notes
• Make sure that the tray support pole is anchored correctly into the hole of the assembled bracket and the foot
end socket.
• Foot end functionality stops when you insert equipment into the sockets at the foot end of the product.
A
Figure 1-125: Bracket and bracket back
Figure 1-127: Installing the screw knob
www.stryker.com
Accessories
(Figure 1-125 on page 1-109) onto the end of the foot end foley bag
(Figure 1-126 on page 1-109).
(Figure 1-127 on page 1-109).
Figure 1-126: Installing the bracket back and bracket
Figure 1-128: Installing the tray support
2141-800-1 07 REV A
English
EN
1-109