Installation; Installing The Xprt Therapy Support Surface (Optional); Installing The Positionpro Support Surface (Optional); Installing The Isolibrium Support Surface (Optional) - Stryker InTouch Critical Care Bed Manuel D'exploitation

Installing the XPRT Therapy support surface (optional)

English
EN
To install the XPRT support surface option onto InTouch, see the installation instructions in the XPRT support surface
operations manual.

Installing the PositionPRO support surface (optional)

To install the PositionPRO support surface option onto InTouch, see the installation instructions in the PositionPRO
support surface operations manual.

Installing the Isolibrium support surface (optional)

To install the Isolibrium support surface option onto InTouch, see the installation instructions in the Isolibrium support
surface operations manual.

Installing iBed Wireless (120V North American only) (optional)

WARNING
• The optional iBed
conditions. It is not intended to replace patient monitoring protocol.
• The line of sight between an iBed Locator and the head end of bed must be free of obstruction at all times. Any
interference could interrupt communication between the iBed Locator and the IR module.
• You must use an iBed
iBed ® Wireless functionality if you use an older version of the footboard.
• You must verify all iBed
product's positions, and that iBed
the loss of information or the transmission of incorrect information.
• You must install the iBed Locators more than 71" apart from one another in the same room (such as in a semi-
private room with more than one product). Failure to do may result in the product transmitting information to the
incorrect iBed Locator.
• Do not use iBed
transmit product information. They are not intended to transmit nurse call information.
You must install the iBed Locator on the wall at the head end of the product. The iBed Locator communicates with the IR
Module that is installed onto the product.
To install the iBed Locator, see the installation instructions that were included with your iBed Locator installation kit. After
you install the iBed Locator, you must configure the wireless connection settings for the iBed Server application.
To configure the iBed Server application, see the installation and configuration instructions in the iBed Server
Installation/Configuration manual.
WARNING
• Always correctly associate or map the iBed Locator to the room or location to provide accurate location information.
Failure to properly map the iBed Locator to the room or location may result in the product transmitting incorrect
information.
• If you move an iBed Locator after it has been installed and mapped, you must remap to the new room or location in
which it is moved to. You must also remap the iBed Locator if you change the room or location information after
initial installation.
If you have any problems during the iBed Wireless installation process, contact Stryker Technical Support at 1-800-327
−0770.
1-18
® Wireless function is only intended to provide remote information of product status and parameter
® Wireless compatible footboard with an iBed
®
Wireless functionality after installation. Verify that the iBed locator communicates the
®
Wireless communicates with the wireless access point. Failure to do may result in
® Wireless to replace the existing nurse call system. iBed

Installation

® Wireless compatible product. You will lose
® Wireless products are only intended to
2141-800-1 07 REV A www.stryker.com