Product Inspection; Nursing Care; Transferring A Patient To And From The Impression™ Non-Powered Mattress; Incontinence / Drainage - Stryker Impression 2980 Série Manuel D'utilisation Et D'entretien

The condition of the Impression™ non-powered mattress is the responsiblity of the owner . There is no setup required
to use this product only an inspection of the mattress and cover prior to first time use. A qualified service technician
should inspect the product thoroughly and confirm the items listed below are free from damage prior to putting into
service . Product inspection is recommended during routine care .
Verify there are no rips, cracks, tears or holes in the mattress cover .
Verify the mattress cover straps are intact and not damaged .
TRANSFERRING A PATIENT TO AND FROM THE IMPRESSION™ NON-POWERED MATTRESS
WARNING
Do not transfer the patient from one bed to another using the mattress with a patient on it . Doing so can result in serious
patient injury .
1 . Position the patient along the center line of the mattress .
2 . Lock the brakes on both bed surfaces .
3 . Adjust the height of the bed to the same level as the surface to which (or
from which) the patient is to transfer .
4 . Transfer the patient following all applicable safety rules and institution
protocols to ensure patient and caregiver safety .

INCONTINENCE / DRAINAGE

Disposable diapers or incontinence pads may be used . Ensure to provide appropriate skin care following each
episode .
WARNING
It is the caregiver's responsibility to monitor the patient's condition at regular intervals to ensure patient safety . Consult
physician if erythema or skin breakdown occurs .
Return To Table of Contents
1-8

Product Inspection

Nursing Care

2980-009-005 REV A www.stryker.com