Adjusting The Height Of The Cot - Stryker Power-PRO IT Manuel D'utilisation

ADJUSTING THE HEIGHT OF THE COT

English
WARNING
• Grasping the cot improperly can cause injury. Keep hands, fingers and feet away from moving parts. To avoid injury,
use extreme caution when placing your hands and feet near the base tubes while raising and lowering the cot.
• Ensure proper hand placement on hand grips. Hands should be clear of red safety bar pivots while loading and
unloading the cot or whenever changing height position of the cot with two or more operators.
You can raise or lower an unoccupied cot with one operator. If a patient is on the cot, a minimum of two (2) trained
operators (one located at each end of the cot) are required to raise or lower the of the cot.
To raise or lower an unoccupied cot:
1. Operator 1 (Foot End) − Grasp the cot frame at the foot end and press either the extend (+) button on the control
switch to raise the litter or the retract (–) button on the control switch to lower the litter to the desired position.
To raise or lower the cot with a patient:
1. Operator 1 (Foot End) − Grasp the cot frame at the foot end and press either the extend (+) button on the control
switch to raise the litter or the retract (–) button on the control switch to lower the litter to the desired position.
2. Operator 2 (Head End) − Maintain a firm grip on the outer rail until the cot is securely in the desired position.
Note: If the extend (+) button on the control switch remains activated after reaching the set load height, the motor will
remain halted until the operator releases the button. After the button is released, press the extend (+) button again to
"jog" the cot height up further.
CAUTION
Do not "jog" the cot past the established cot load height of the product when the safety bar engages the vehicle safety
hook or damage may occur to the product.
Return To Table of Contents
1-32
Operation Guide
6516-109-005 REV B www.stryker.com