Transferring A Patient Off The Cot - Stryker Speed-Sheet 6010 Manuel D'utilisation

TRANSFERRING A PATIENT OFF THE COT

1. Position the cot alongside the receiving patient support platform.
2. Adjust the cot height so the cot mattress is flat and approximately 1 in (2.5 cm)
above the receiving patient support surface.
3. Secure the cot and patient support platform together to prevent separation.
4. Lower all siderails.
5. Tear at least one red tab 3-6 in (8-16 cm) to activate Speed-Sheet (Figure 3 or
Figure 4). Note: Tearing more than one tab can improve performance.
Figure 3
6. With at least one operator on each side of the patient, pull on the linen sheet to
transfer the patient (Figure 5).
Note: Pull on the linen sheet. Do NOT pull on Speed-Sheet.
Pull horizontally. Do NOT lift the linen sheet.
An overhand grip on the linen sheet encourages proper pulling technique.
7. Raise the siderails on both
sides of the patient after
the transfer.
8. Dispose of the activated
Speed-Sheet
to local medical disposal
protocol and replace it with
a new one before the next
response.
www.stryker.com
Operation Guide
according
6010-009-005 REV A
Figure 4
Figure 5
Return To Table of Contents
English
1-7