Transferring A Patient With The Patient Transfer Board; Using The Patient Transfer Board As An Armboard - Stryker 1037 Manuel D'utilisation

English

TRANSFERRING A PATIENT WITH THE PATIENT TRANSFER BOARD

WARNING
When using the transfer board to transfer a patient from one patient support platform (for example, bed, stretcher, gurney,
operating table) to another, always lock the brakes on both patient support platforms. Make sure that the transfer board
is placed securely on the surface of the patient support platforms. The patient support platforms and surfaces must be
at the same height before the patient is transferred.
B
Figure 6.1: Transfer Board
Return To Table of Contents
1-18
Operation Guide
To transfer a patient with the patient transfer board:
A
Note: The transfer board (C) is located between the siderail (A) and
MATING
the mattress (B) as shown in Figure 6.1.
BED
1. Lower the siderail (A) to the lowest position.
2. Raise the transfer board (C) from the bottom while lifting from
the top.
3. When the transfer board is fully raised, it can be pivoted downward
C
onto the surface of the mating bed or stretcher.
Note: Make sure that the brakes have been applied on both the
stretcher and the mating bed or stretcher before beginning step 4.
4. Using a sheet, draw the patient onto the mating bed or stretcher.

USING THE PATIENT TRANSFER BOARD AS AN ARMBOARD

To use the transfer board as an armboard (Figure 6.2):
1. Raise the support post (D) to the highest position.
2. Raise the transfer board (C) from the bottom while lifting from
the top.
3. When the transfer board is fully raised, it can be pivoted downward
onto the support post (D).
When the transfer board is being used to transfer a patient, the
support post (D) must be in the stored (down) position. Damage
to the support post will occur if it is pushed up against a stretcher,
MATING
table, etc.
BED
MATING
BED
CAUTION
Figure 6.2: Transfer Board as an Armboard
1037-009-005 REV B
C
D
www.stryker.com