Optional Zoom ® Drive System (Model 2152/2154/2156 Only) - Stryker InTouch FL27 Manuel D'utilisation

CAUTION (CONTINUED)
• Some cleaning products are corrosive in nature and may cause damage to the product if used improperly . If the
products described above are used to clean Stryker patient care equipment, measures must be taken to ensure
the beds are wiped with a damp cloth soaked in clean water and thoroughly dried following cleaning . Failure to
properly rinse and dry the beds will leave a corrosive residue on the surface of the bed, possibly causing premature
corrosion of critical components . Failure to follow the above directions when using these types of cleaners may
void this product's warranty .
• Clean Velcro after each use . Saturate Velcro with disinfectant and allow disinfectant to evaporate . (Appropriate
disinfectant for nylon Velcro should be determined by the hospital .)
Note
• Throughout this Operations Manual, the words "right" and "left" refer to the right and left sides of a patient lying
on his/her back on the bed .
• The addition of accessories affects the motion of the bed .
• The iBed option is only used as an informational feature and is not supposed to replace normal patient monitoring
protocol .
OPTIONAL ZOOM DRIVE SYSTEM (MODEL 2152/2154/2156 ONLY)
®
In addition to the previous warnings and cautions, all of the following warnings and cautions apply to units equipped
with the Zoom .
®
WARNING
• The 2152/2154/2156 InTouch® Bed is intended for use by trained hospital personnel only . Failure to properly train
personnel could result in injury .
• USE CAUTION while maneuvering the unit with the drive wheel activated . Always ensure there are no obstacles
near the unit while the drive wheel is activated . Injury to the patient, user or bystanders or damage to the frame or
surrounding equipment could occur if the unit collides with an obstacle .
• Use caution when transporting the unit down halls, through doors, in and out of elevators, etc . Damage to the
siderails or other parts of the unit could occur if the unit comes in contact with walls or door frames .
• Put the drive wheel in the neutral position and release the brake before pushing the unit manually . For 2152/2154/2156
models; push the Brake Off button to disengage drive wheel (Zoom
attempt to push the unit manually with the drive wheel engaged . The unit will be difficult to push and injury could
result .
• If unanticipated motion occurs, unplug the power cord from the wall socket, push the battery power on/off switch
to the "OFF" (0) position (the LED will not be illuminated), actuate the drive wheel pedal to the neutral position
and call maintenance .
• The power save mode is activated after one hour on battery power with no motion release switch activation .
Functions including Bed Exit, Scale and Motion will cease to operate when the unit enters the power save mode .
Injury to the patient could occur if proper patient monitoring protocol is not observed .
• Always unplug the power cord and push the battery power on/off switch to the "OFF" (0) position before service
or cleaning . When working under the frame, always support the litter frame to prevent injury in case the Bed Down
switch is accidently activated .
• Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State
of California to cause cancer and birth defects or other reproductive harm . Wash hands after handling .
• Do not modify the InTouch® Model 2152/2154/2156 bed . Modifying the unit can cause unpredictable operation
resulting in injury to the patient or user . Modifying the unit will also void this warranty .
Return To Table of Contents
1-14
Summary of Safety Precautions
2151-009-005 REV B
® ) before pushing the unit manually . Do not
www.stryker.com