EINHELL FREELEXO CAM Instructions D'origine page 62

Troubleshooting
Fault
The robot lawn
mower comes to a
stop in the mowing
area. The robot lawn
mower cannot be
switched on:
The robot lawn
mower cannot move
into the charging
station.
The robot lawn mo-
wer is very loud.
The robot lawn
mower stays in the
charging station.
The robot lawn mo-
wer keeps returning
to the charging
station.
Possible cause
- Battery voltage too low
- Fault in the power circuit or
the electronic components
- The charging station (19) is
not correctly installed.
- Damaged blades (10)
- A large amount of foreign
bodies adhere to the blades
(10)
- The robot lawn mower has
started too close to obstac-
les
- Damaged blade drive or
drive motor
- Other parts of the robot lawn
mower are damaged
- Incorrect work time settings
- The battery charge level is
too low and drops below
30%.
- The rain sensor has tripped.
- The robot lawn mower has
become overheated.
- Twilight is falling, making it
impossible for the camera
unit to work correctly.
GB
- Bring the robot lawn mower back to the
charging station (19) for charging.
- Switch on the main switch (7) (ON).
- Contact your customer service center.
- Check the position of the charging station
(19) and the maximum distance from the
charging station (19)
- Please use a battery with higher capacity
- Caution: When using a Multi-Ah battery
(e.g. 4-6 Ah), set the higher capacity.
Thanks to the gentle charging and di-
scharging of the robot lawn mower there is
no need to use the lower capacity in order
to extend the working life.
- Make sure that the LED display (19a) on
the charging station (19) is lit green.
- Make sure that the guide cables (24) are
connected at the charging station (19)
and that the front guide cable (24) is laid
in the middle underneath the charging sta-
tion (19).
- Make sure that the charging station (19) is
positioned correctly.
- Replace the blades (10). The 3 blades
(10) must all be replaced together at the
same time.
- The operating effi ciency of the robot lawn
mower is dependent on the sharpness of
the blades (10). You should therefore en-
sure that the blades (10) are maintained in
good condition.
- To avoid cutting yourself, be sure to switch
off the robot lawn mower and wear work
gloves while you clean the blades (10).
- Arrange for the motor to be repaired or
replaced by your customer service center.
- Check the work time settings.
- The robot lawn mower will begin and end
its work in accordance with the set time
window. Outside this time window the
robot lawn mower stays in the charging
station (19).
- 62 -
Remedy