EINHELL FREELEXO CAM Instructions D'origine page 57

11. Charging station display and troubleshooting
LED display (19a)
Off
Lit green
Flashing green
Lit red
12. Robot lawn mower display and troubleshooting
Rain sensor LED
(53)
Flashing yellow
GNSS LED (54)
Flashing green
Lit green
Flashing yellow
Lit yellow
Lit red
Description
- No power supply
- Ready for mowing
- The battery is fully charged
- The guide cable (24) is con-
nected
- The guide cable (24) is se-
vered
- The battery is being charged
Description / possible cause
- The rain sensor (5) has trip-
ped.
Description / possible cause
- The robot lawn mower
searches for a GNSS con-
nection and calibrates the
position of the charging stati-
on (19).
- The GNSS signal is not pre-
cise
- The robot lawn mower has
calibrated the position pf the
charging station (19) with the
help of GNSS.
- The GNSS signal is precise
- There is no GNSS signal
- The robot lawn mower is too
far from the charging station
(19).
- Hardware fault on the GNSS
module
GB
- Check the power supply
- Examine the guide cable (24) for a break
- Wait until the battery is fully charged
- Wait until the robot lawn mower is dry.
- A detailed description of the sensor can
be found in section 5.2.
- Wait for calibration to end.
- If the GNSS LED (54) fl ashes perma-
nently, the received signal is very weak
(blocked by a building or tree) and the po-
sition of the charging station (19) should
be adapted.
- The robot lawn mower is ready.
- Make sure that the robot lawn mower is
outside and that the GNSS signal is not
being blocked.
- Move the robot lawn mower into the mo-
wing area which is near the charging stati-
on (19).
- Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to re-
start the robot lawn mower.
- Contact your customer service center.
- 57 -
Solution
Solution
Solution