Removing The Head Board; Night Light; Nurse Call Battery - Stryker 4701 Manuel D'utilisation

Bed Operation

REMOVING THE HEAD BOARD

To remove the head board, lift it straight up and off the bed. To replace the head board, align the plastic inserts
on the bottom of the head board with the slots at the head end of the bed and lower the head board until it
completely seats in the slots.

NIGHT LIGHT

The bed is equipped with a night light to illuminate the floor area around the bed. The night light will automati-
cally activate when the light in the room becomes dim enough.

NURSE CALL BATTERY

To prevent a low battery condition when the bed is not plugged in, position the cord out switch at the head
end of the bed to the off position. The switch is identified by the label shown below. If the switch is not posi-
tioned as shown below and the bed power cord and pendant cord are unplugged, the life of the back−up bat-
tery will be significantly reduced.
If the POWER LED (located on the outside of both siderails) is flashing, the 9V Nurse Call battery needs to
be replaced. The battery is located at the head end of the bed. No tools are required to replace the battery.
Unplug the bed power cord from the wall socket and replace the battery. After replacing the battery, verify
the POWER LED is no longer flashing and operates normally when the different light settings are selected.
Properly dispose of the old battery in accordance with local regulations.
1−18