Bed Extender With Scale - Fa64172 - Stryker GoBed II Lit MedSurg FL28EX Guide D'utilisation

The bed extender is designed to temporarily increase the mattress support by 10" on beds equipped with the optional
scale system . It also allows the installation of an 80" or 84" long mattress . A cushion (DM64063 for a 6" thick mattress)
must be ordered separately to accompany the extension .
WARNING
• The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation .
Refer to the "Add / Remove Equipment" procedure
• The surface added by the bed extender is not included in the area monitored by the Bed Exit system .
• Do not perform this procedure while a patient is in the bed .
INSTALLATION
Tools Required:
• #2 Phillips Screwdriver
Procedure:
1 . Apply the brakes .
2 . Unplug the bed from the wall socket .
3 . Remove the foot board .
4 . Before installing the extender, adjustments must be made depending on the length of mattress being used:
Configuration with 80" Mattress
Support assembled
Return To Table of Contents
1-34

Bed Extender with Scale - FA64172

Note the position of the foot
end mattress retainer .
28EX-009-001 REV B
(page 1-21) .
Configuration with 84" Mattress
www.stryker.com