Honda BF40D Manuel D'utilisation page 624

e. INSTALLATION
1) Set the tiller handle assembly on the outboard motor, and tighten the two 10 mm washers and the two 10 x 32 mm
hex bolts to the specified torque.
1
TORQUE: 34 N . m (3.5 kgf . m, 25 lbf . ft)
2
[1]
3
TILLER HANDLE
ASSEMBLY
4
5
6
7
8
9
10
11
12
2) Clamp the handle cable using the harness band clip.
13
Install the remote control cable plate.
14
3) Pass the handle cable, starter cable and the two remote
control cables through the under case grommet A in the
15
positions shown.
Install the under case grommet A on the engine under case.
16
4) Install the remote control cables on the remote control
cable plate aligning the groove in each cable with the
17
corresponding recess in the cable plate.
18
[9]
REMOTE CONTROL CABLE
19
[THROTTLE SIDE]
INSTALLATION HOLE
20
[13]
STARTER CABLE
INSTALLATION
HOLE
[12] <VIEWED FROM THE TILLER HANDLE SIDE>
16-33
[3]
10 x 32 mm
HEX BOLT (2)
[10]
REMOTE CONTROL
CABLE [SHIFT SIDE]
INSTALLATION HOLE
[11]
HANDLE CABLE
INSTALLATION
HOLE
[6]
UNDER CASE
GROMMET A
624
[2]
10 mm WASHER (2)
[1]
[2]
REMOTE CONTROL
REMOTE CONTROL
CABLE [THROTTLE SIDE]
CABLE [SHIFT SIDE]
[8]
RECESS
[7]
REMOTE CONTROL
CABLE PLATE
[6]
UNDER CASE
GROMMET A
[5]
HANDLE
CABLE
[4]
HARNESS
BAND CLIP
[3]
GROOVE