Honda BF40D Manuel D'utilisation page 472

36) Wind the seal tape onto the threads that are at the end of
the piston rod.
1
37) Apply ATF to the end of the piston rod and the O-ring on
the outer tube, and install the outer tube on the
2
cylinder/piston rod assembly.
• Install the outer tube while turning it with care not to
3
damage the O-ring.
4
5
38) Screw in the outer tube two or three ridges of the threads,
and apply the thread locking agent (LOCTITE
equivalent) to the threads.
6
39) Tighten the outer tube to the specified torque.
7
NOTICE
8
To tighten the outer tube, use the special tool and read the
torque as follows.
9
TOOL:
Lock nut wrench, 30 x 40 mm
10
• Tighten the outer tube with care not to move the bottom
11
piece out of the vise.
12
[5]
13
TORQUE WRENCH
14
15
16
[7] TORQUE WRENCH
17
• Formula:
18
[8] Torque wrench reading =
[9]
19 Torque wrench effective length [m (ft)] x Specified torque [N . m (kgf . m, lbf . ft)]
[9] Torque wrench effective length [m (ft)] + 0.05 [m (0.164 ft)]
20
TORQUE: 64 N . m (6.5 kgf . m, 47 lbf . ft)
• Example:
Torque wrench reading in case of using a torque wrench
which effective length is 0.4 m (1.31 ft)
0.4 [m (1.31 ft)] x 64 [N . m (6.5 kgf . m, 47 lbf . ft)]
0.4 [m (1.31 ft)] + 0.05 [m (0.164 ft)]
= 57 [N . m (5.8 kgf . m, 42 lbf . ft)]
40) Remove the piston rod/outer tube assembly from the vise,
and wipe up the excess of the thread locking agent.
14-27
®
07916-9690000
[6]
LOCK NUT WRENCH,
30 x 40 mm
[0.05 m
EFFECTIVE LENGTH
(0.164 ft)]
[m (ft)]
[10]
[1] SEAL TAPE
[3]
PISTON ROD
241 or
[4] OUTER TUBE
[4]
LOCK NUT
WRENCH,
30 x 40 mm
07916-9690000
[1] OUTER TUBE
472
[2]
Wind the tape
onto the threads.
[1] OUTER TUBE
[2]
Apply thread locking
®
agent (LOCTITE 241
or equivalent).
[3] BOTTOM
PIECE