Honda BF40D Manuel D'utilisation page 330

14) Install the drain plug cover and the 6 x 10.5 x 25 mm distance collar on the extension case, and tighten the 6 x 35 mm
special screw to the specified torque.
1
TORQUE: 6.5 N . m (0.7 kgf . m, 4.8 lbf . ft)
2
15) Set the under cover on the extension case and install the 5 mm plate nut on the under cover.
Set the 5 x 7 x 38 mm distance collar and the 5 x 7 x 23 mm distance collar on the under cover, and tighten the two
5 mm washers, 5 x 45 mm screw and the 5 x 30 mm screw to the specified torque.
3
TORQUE: 3 N . m (0.3 kgf . m, 2.2 lbf . ft)
4
16) Install the six 8 x 15 mm rivet screws on the under cover.
5
17) Install the following parts.
- Gear case assembly/extension separator [Semi-long/extra-long shaft types only] (P. 11-5)
6
- Engine cover (P. 4-2)
7
8
9
10
11
12
13
14
15
16
17
18
19
20
[11]
DRAIN PLUG COVER
[10]
10 x 10.5 x 25 mm
DISTANCE COLLAR
11-55
[1]
5 x 45 mm SCREW
[2]
5 x 7 x 38 mm
DISTANCE COLLAR
[8]
5 x 30 mm SCREW
[9]
6 x 35 mm SPECIAL
SCREW
330
[3]
5 mm PLATE NUT (2)
[4]
8 x 15 mm RIVET
SCREW (6)
[5]
UNDER COVER
[6]
5 x 7 x 23 mm
DISTANCE COLLAR
[7]
5 mm WASHER (2)