Honda BF40D Manuel D'utilisation page 470

32) Apply ATF to the outer surface of the lower part of the
cylinder and to the inner wall of the bottom piece.
Install the cylinder/piston rod assembly on the bottom
1
piece.
NOTICE
2
Do not damage the O-rings during installation.
3
4
5
6
7
8
33) Hold the bottom piece in a vise using a shop towel or
equivalent material, and hold the cylinder/piston rod
9
assembly upright.
10
NOTICE
Do not tighten the vise excessively, as it can damage the
11
bottom piece.
34) Pour the ATF into the cylinder slowly not to foam it. Pour
12
up to the top of the cylinder.
13
14
15
16
17
18
19
35) Apply ATF to a new O-ring, and install it in the groove
inside the outer tube.
20
NOTICE
Install the O-ring with care not to damage it.
14-26
[1]
CYLINDER/PISTON
ROD ASSEMBLY
[2]
BOTTOM PIECE
[1]
CYLINDER/PISTON
ROD ASSEMBLY
[2]
BOTTOM PIECE
(ATF)
470
(ATF)
(ATF)
[1] O-RING
[2] OUTER TUBE